So you’ve had your trusty Vax dual power carpet cleaner for a while now and it’s done a bang up job of keeping your carpets looking fresh. But like any good tool, it needs a little TLC itself from time to time to keep running smoothly.
Emptying and Cleaning the Dirty Water Tank
The dirty water tank is where all that grimy water from your carpets gets collected during a cleaning session. Over time, it’ll start to get gunked up in there. So the first step is to empty it out. Lift up the clips on the sides and pull the tank straight off the carpet cleaning machine.
Then remove the lid and pour the dirty water from cleaning your carpets down the drain. Give it a good rinse under the tap to wash away any leftover dirt or carpet fibers. Be sure to let all the parts air dry completely before putting it all back together.
Wiping Down the Outside
Now it’s time to give the outside of the Vax dual power carpet cleaner a wipe down. Use a damp cloth to wipe away any dust or dirt that may have accumulated on the outer casing during use. Pay special attention to all the nooks and crannies. You’ll be surprised how much gunk can build up in little spots if you don’t clean them out regularly. Make sure to dry it all off thoroughly when you’re done.
Vacuuming the Brush Roll and Inside Compartment
The brush roll is what does all the heavy lifting when it comes to loosening up dirt in your carpets. Over time, fibers and particles can get wrapped up in there. So take out your vacuum and go to town on the brush roll. Spin it by hand while vacuuming to dislodge any debris. You can also use scissors to cut away any threads that may be tangled in there.
Next, vacuum inside the main compartment where the brush roll sits. Get into all the corners and crevices. This helps remove any lingering dirt or dust before moving on to the next steps.
Cleaning the Filters
Your Vax dual power carpet cleaner has various filters to catch fine particles and keep them from recirculating back into the air. Cleaning these regularly is key to maximum suction power. Remove the filters, usually located under a removable panel, and rinse them thoroughly under running water. For stuck-on gunk, let them soak in a 50/50 white vinegar and water solution before scrubbing. Rinse well and allow to air dry completely before replacing.
Flushing Out the Hoses and Wands
Over time, residue can build up in the hoses and attachments like the crevice tool or upholstery wand. To flush them out, fill the clean water tank with warm, soapy water and run the carpet cleaning machine. Direct the wand into a bucket to catch the soapy water coming out of it. Do this for each hose and attachment individually. Rinse well with clean water at the end.
Scrubbing Tough Stains
For any really tough, stuck-on stains inside the Vax dual power carpet cleaner, you may need to get in there with a toothbrush. Wet it under the tap and scrub away at hardened residue in hard to reach areas. Be sure to rinse thoroughly when you’re done.
Drying and Storing
Make sure all parts are completely dry before storing your Vax dual power carpet cleaner away. This helps prevent any mold or mildew growth. As a last step, wipe down the outside with a microfiber cloth to remove any remaining water spots. Store in a cool, dry place until its next carpet cleaning job!
Final Thought
That about covers it for deep cleaning your Vax dual power carpet cleaner! Following these steps will help extend the life of your machine and keep it performing at its best. Don’t forget to also clean it after every 2-3 regular carpet cleaning jobs. A little maintenance goes a long way to keeping your carpet cleaning machine running smoothly for floor freshening far into the future.